Marquis 500 Sport Bridge Owner's Manual page 66

Ac cOntROL pAnEL (SALOn
AFt cAbinEt)
SHOWERS AND SINKS
Shower
A shower is installed in each of the Head Rooms .
SInk
A sink is installed in each of the Head Rooms, Galley, and the Cockpit Wet Bar .
Used (grey) water from the sinks and showers drain into the sump . The sump is located below the yacht's waterline . A pump is
needed to drain the sump and discharge its water overboard or into an optional grey water holding tank .
The sump pump operates automatically when water in the sump rises above the pump's manufactured level . The automatic operation
occurs only when the FORWARD SUMP PUMP, and AFT SUMP PUMP circuit breakers are ON . The breakers are located on the DC
Control Center (Engine room, aft bulkhead) .
tranSom hand Shower
The transom hand shower supplies warm, fresh water after swimming or before entering the aft STBD locker (See Internal Water
System Illustration on the previous pages) . The hand shower is especially useful when the yacht is operated in salt water . The hand
shower is an integral part of the yachts fresh water system . Simply, turn on the faucet and adjust for the desired water temperature .
The hand shower and mixing valve is located on the transom STBD side .
FRESh WATER WAShDOWNS (OPTION)
The optional bow and transom fresh water washdowns supplies water from the fresh water tank to washdown and clean the yacht .
The fresh water washdown is especially useful if the yacht is operated in salt water .
A Tip From Marquis!
the fresh water washdown system draws water from the yacht's fresh water tanks. the amount of fresh water in the
water tanks is quickly reduced by prolonged use of the washdown system.
uSIng the freSh water waShdownS:
1 . Locate the bow and transom mounted hose fittings . The bow mounted fitting is located on the fore deck in the fore peak locker .
Two transom mounted fitting are located in the cockpit, one in each locker, located in the PORT and STBD weatherboards .
2 . Attach one end of an appropriately sized nylon water hose to the fitting of choice .
3 . Attach a nozzle to the other end of the hose .
52
3 . Locate the AC Control Panel (Salon):
3a . Switch ON located on the Main circuit breaker
3b . Switch ON the WATER HEATER circuit breaker
4 . Refer to the OEM information for details on operating the water heater .
CauTiON
DO nOt SUppLy pOWER tO thE WAtER hEAtER WhiLE Empty. DAmAgE mAy
OccUR tO thE hEAting ELEmEnt. FiLL, pRESSURizE, AnD pRimE thE FRESh
WAtER SyStEm bEFORE tURning On thE WAtER hEAtER, AS DEScRibED
in: Filling the Water tank AnD Pressurizing and PriMing the Water
systeM in SEctiOn 4.
I I S S
nternal nternal
5027 • E5 09/2011
yStemS yStemS