Samsung SyncMaster 17GLi User Manual page 14

First Function : Pincushion / Trapezoid
Push this button once to adjust the pin-
cushion and trapezoid of the display.
Pincushion control
l
Push G / D button once to display the pin-
cushion OSD. To adjust the vertical sides
of the display from bowing in ( pincushion
) or bowing out ( barrel distortion ), use the
left and right (b) buttons until the
sides are straight.
Trapezoid control
l
Push G / D button once to display the pin-
cushion OSD. Push either the up
down ( V) button to display the trapezoid
OSD. Use the up (A) and down (V) but-
tons again to correct any trapezoid
distortion of the display.
Second Function : Parallel/ Tilt
Push this button twice to adjust the
parallel and tilt of the display.
Parallel control
l
Push G / D button twice to display the par-
allel OSD. Adjust the parallel of the dis-
play with the left (4) and right ( .)
buttons.
Tilt control
l
Push G / D button twice to display the tilt
OSD. Push either the up ( A) or down (V)
button to display the tilt OSD. Use the up
rect the tilt of the display.
9. E$$$ Color Temperature
Use this button to choose the color tem-
perature of the display. After pushing the
color temperature button, use the up
or down ( V) button to select between
9300°K color ( channel 1 ) and 6500°K color
( channel 2 ).
10. - Recall
Use this button to recall factory mode set-
tings. When you push the recall button,
the indicator LED changes color from
green to orange ( the same as any other
function ) and the OSD appears.
Hold down the recall button for several
seconds, or until the indicator LED's color
changes to green. A green LED indicates
that the factory settings for that timing
have been recalled. The OSD shows the
progress of the recall function.
Note: This operation resets all of the data
or
in the user memory area for the current
timing signal.
11. @ Degauss
Magnetic fields can build up on the CRT
and cause color impurity. Use the degauss
button to demagnetize the CRT. Push the
button once to activate the degaussing cir-
cuit. The degaussing circuit automatically
turns itself off after a few seconds.
button for longer than 5 seconds. If you do,
this operation resets all of the data in the
user memory area. If this occurs, you must
remake your user adjustments.
ENGLISH
12