7. Insert two fingers into the holes in the two tabs on the front of the blue bracket. Then, press the tabs
towards each other and carefully slide the non-hot-swap hard disk drive out of the front of the chassis.
Figure 64. Sliding the non-hot-swap hard disk drive out of the bay
8. Flex the sides of the blue bracket to remove the non-hot-swap hard disk drive from the bracket. Save
the bracket for future use.
Note: Do not touch the circuit board on the hard disk drive.
9. Reinstall the front system fan 1. See "Replacing the front system fan" on page 149.
2
1
U
U
C P
C P
M
M
M E
M E
U
U
P S
P S
.
Chapter 6
Installing, removing, or replacing hardware
127