Lenovo ThinkServer User Manual page 115

This topic provides instructions on how to install the TR 100 key.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Use any documentation that comes with the TR 100 key and follow those instructions in addition to
the instructions in this topic.
To install the TR 100 key, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 85.
3. Lay the server on its side for easier operation.
4. Touch the static-protective package that contains the TR 100 key to any unpainted surface on the
outside of the server. Then, take the TR 100 key out of the package.
5. Locate the iButton socket on the system board. Insert one side of the TR 100 key under one of the
retaining clips on the iButton socket. Then, carefully press the other side of the TR 100 key straight
down until the key snaps into position and is secured by the two retaining clips on the iButton socket.
Note: If necessary, remove any parts or disconnect any cables that might impede your operation.
Figure 45. Installing the TR 100 key
What to do next:
• To work with another piece of hardware, go to the appropriate section.
.
Chapter 6 Installing, removing, or replacing hardware
103