Inserting The Melitta ® Claris ® Water Filter - Melitta CaffeO Solo Operating Instructions Manual

6 Inserting the Melitta
A Melitta Claris water filter is supplied with the appliance for filtering out limescale
® ®
and other contaminants. Please only insert it after starting up the appliance
for the first time. If you use the filter, you will have to descale the appliance less
frequently and the water hardness will automatically be set to hardness level 1 (see
page 54). The service life of your appliance will be extended thanks to the reliable
protection from limescale. The water filter should be changed regularly (every 2
months); at the latest, however, it must be changed when the symbol for the water
filter is shown on the display.
Prerequisite: The appliance must be switched off (see „Switching on and off"
on page 49).
• Simultaneously press both the button for coffee strength
ON/OFF button
→ The symbol for the water filter
procedure. The symbol for the drip tray
• Empty the drip tray and then reinsert it.
→ The symbol for the water tank
• Put the water filter in a glass with fresh tap water for several minutes
before you insert it.
• Open up the flap of the water tank (Fig. A, no. 6) and pull the water tank
up and out of the appliance.
• Empty the water tank.
• Screw the Melitta
bottom of the water tank.
• Fill the water tank to the max. mark with fresh tap water and reinsert it.
• Press the button for coffee strength
→ The device will execute an automatic filter rinsing process; hot water in the
interior of the appliance flows into the drip tray. Subsequently the standby
symbol
50 50
for more than 2 seconds.
Claris water filter carefully into the thread on the
® ®
and bean symbols
Claris water filter
® ®
flashes during the entire change
is illuminated.
illuminates.
.
will be illuminated.
and the