Table of Contents
Advertisement
NYLON LINE HEAD INSTALLATION
1. Align hole in upper plate with notch in edge of gear housing and
insert head locking tool (C).
2. Be sure upper plate (A) remains on PTO shaft.
3. Place line head onto PTO shaft. Followed by large metal washer.
4. Thread L.H. nut on PTO shaft. Tighten securely.
5. Install new split pin.
6. Remove locking tool (C).
NYLON LINE INSTALLATION
1. Shut engine off. Lay unit on the ground with head assembly up.
2. Remove old nylon line through center recess of head.
3. Thread new lines through outside holes (D) in housing until ends
meet in center of recess.
NOTE
Insert cutting line ends to center of head recess to insure easy
removal of used lines.
FRONT HANDLE INSTALLATION
NOTE
Label shows minimum spacing for front handle location.
1. Position front handle for comfortable operation and secure screws.
G
T
RASS
RIMMER
O
PERATOR
D
/B
C
RUSH
UTTER
'
M
S
ANUAL
C
A
MIN
SPACING
11
D
Advertisement
Table of Contents
