U-Line SS1095 User Manual page 16

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
6. Install hinge on opposite side at bottom of cabinet.
Align hinge outer edge with cabinet before tightening
screws.
7. Relocate plastic spacer/bushing on top and bottom of
door to opposite side. Clean out bushing hole in door
bottom with a screwdriver if necessary.
1
8. Using a Phillips screwdriver, remove the two screws
holding the custom stainless handle from the original
location and remove the handle. Remove the two
screws on the opposite side of the door. Do not place
handle on door until you have completed steps 9 and
10.
9. Remove plastic hole plug from door handle and
relocate to opposite side. Lift the handle slightly and
press on the locking tab, then gently pry the hole plug
out of the hole, being careful not scratch the top cap.
Hinge
Plastic
Hole Plug
Screw
Right Side
Door Swing
Right Side Invert
Hinge Screw
10.Relocate plastic spacer/bushing on top of door that was
underneath the hinge to the opposite hole in top cap.
11.Attach handle removed in Step 8 to opposite side of
door frame. Be sure to tighten all four screws removed
in Step 8.
12.Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge.
Press in locking tab, then
lightly pry up to remove
hole plug and move to
opposite side
u-line.com
Plastic
Hole Plug
Left Side
Door Swing
Invert
Hinge
Door Adjustments 2