Inserting The Battery; Charging The Battery In The Camera - Konica Minolta DiMAGE X1 Instruction Manual

INSERTING THE BATTERY

This digital camera uses one NP-1 lithium-ion battery. Before using the battery, read the safety
warnings on page 3 of this manual. When replacing the battery, the camera should be turned off
(p. 21).
1
2
1. Slide the battery-chamber door toward the front of the camera to release the safety catch; the
door springs open.
2. Move the battery latch towards the back of the camera to insert the battery. With the battery ter-
minal first and the printing toward the front of the camera, slide the battery into the battery cham-
ber until it is caught by the latch.
To remove the battery, slide the latch towards the back of the camera until the battery is released.
Pull the battery out of the chamber.
3. Close the battery-chamber door and slide it toward the back of the camera to engage the safety
catch.
After installing the battery, the set-time/date message may appear on the monitor, see page 22 on
how to set up the clock and calender.
16 Getting up and running
3

CHARGING THE BATTERY IN THE CAMERA

Battery can be charged without removing it from the camera.
1. Insert the battery to the camera (p. 16).
2. Plug the power cord into the cradle and a live household outlet (p. 15).
3. Turn the camera off and place it in the cradle with LCD
monitor facing forward. The charging lamp glows to show
the battery is charging. The lamp goes out when the bat-
tery has been charged. Charging time is approximately
two hours.
4. When the charging lamp goes out, remove the camera
from the cradle first, then unplug the power cord.
Charging lamp
The camera must be off when inserting it into the cradle, otherwise the battery will not charge. If the
charging lamp blinks, confirm a battery is in the camera.
Keep cradle terminal clean. Dirty terminals may prevent charging.
17