Cleaning And Maintenance - Black & Decker CV1205 Original Instructions Manual

Assembly
Fitting the accessories (fig. A & C)
These models are supplied with the
following accessories:
a crevice tool (7) for confined spaces
u
a brush tool (8) for furniture and stairs
u
To fit an accessory, proceed as follows:
Take the accessories from the
u
appliance.
Insert the appropriate accessory into
u
the front of the appliance.
Use
Before first use, the battery must be
u
charged for at least 24 hours.
Place the appliance on the charging
u
base whenever it is not in use.
Charging the battery (fig. B)
Make sure that the appliance is
u
switched off. The battery will not be
charged with the on/off switch in the
on position.
Place the appliance on the charging
u
base as shown.
Plug in the charger. Switch on at the
u
mains.
The charging indicator (6) will be lit.
Leave the appliance to charge for at
u
least 24 hours.
Whilst charging, the charger may become
warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
The charging indicator will be lit as long
as the appliance is connected to the
plugged-in charger.
Warning! Do not charge the battery at
ambient temperatures below 10 °C or
above 40 °C.
Switching on and off (fig. D)
To switch the appliance on, slide the
u
on/off switch (1) forward.
To switch the appliance off, slide the
u
on/off switch back.
8
CV1205/CV9605 - Optimising the
suction force (fig. E)
In order to keep the suction force optimised,
the filter must be cleared regularly during
use.
Rotate the wheel (5) a few turns to
u
shake out dust clogging the filter (9).

Cleaning and maintenance

Warning! Regularly clean the filters.
Cleaning the dust bowl and filters
(fig. F - J)
The filters are re-usable and should be
cleaned regularly.
Press the release button (2) and
u
remove the dust bowl (3) (fig. F).
Empty the dust bowl (fig. G).
u
Remove the filters (9 & 10) by twisting
u
them clockwise (fig. H).
Brush any loose dust off the filters.
u
Wash the filters in warm, soapy water
u
(fig. I). The bowl can also be washed
if necessary. Do not immerse the
appliance in water (fig. J).
Make sure the dust bowl and filters
u
are dry.
Refit the filters (9 & 10) onto the
u
appliance, twisting them
counterclockwise until they lock into
place.
Refit the dust bowl onto the appliance.
u
Make sure the dust bowl clicks into
place.
Warning! Never use the appliance without
the filters. Optimum dust collection will
only be achieved with clean filters and an
empty dust bowl.
CV1205/CV7205/CV9605 -
Cleaning the exhaust filter (fig. K)
Open the lid (11).
u
Remove the filter (12) from the recess.
u
Wash the filter in warm, soapy water.
u
Make sure the filter is dry.
u
Refit the filter (12).
u
Close the lid.
u