Servicing Notes - Sony STR-KS600PM Service Manual

UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
SECTION 1

SERVICING NOTES

NOTES ON REPLACEMENT OF THE DIGITAL BOARD
New part of EEPROM (IC1131) on the DIGITAL board cannot be
used. Therefore, if the mounted DIGITAL board (A-1097-941-A)
is replaced, exchange new microcomputer and new EEPROM with
that used before the replacement.
STR-KS600PM/KS600PW
3