KitchenAid Job Aid 4322312 Technical Education page 20

Removing the Damper Control
1. Remove the control box from the unit.
2. Unclip the damper control from the two mounting posts and slide it up and off the posts.
NOTE: Before installing a service replacement damper, rotate the control shaft full
counterclockwise. Install the rack slide in the far right position to synchronize
the damper setting properly.
Removing the Freezer Temperature Control
1. Remove the control box from the unit. (Fig. 22 - page 12)
2. Unclip the freezer temperature control from the mounting post and lift it off.
3. Remove the gasket material and electrical wiring tape securing the temperature -sensing tube
to the control box and unclip the tubing from the stud.
NOTE: Before installing a service replacement freezer temperature control, rotate the
control shaft fully counterclockwise. Install the rack slide to the far right position
to synchronize the thermostat setting properly.
When reassembly the control box, make sure the temperature-sensing tube is
clipped in placing and taped to the control box stud. Slide the insulating cap
over the tube and onto the post to seal the hole in the divider between the
freezer and refrigerator compartments.
Removing the Defrost Timer
1. Remove the control box from the unit.(Fig. 22 - page 12)
2. Unclip the timer from the mounting post.
3. Unplug the the wiring harness connector from the timer terminals.
Removing the Light Switch
1. Remove the control box from the unit.(Fig. 22 - page 12)
2. Snap the switch out of its mounting hole in the control box.
3. Unplug the wire connectors from the switch terminals.
Removing the Exterior Cabinet Moisture Switch
1. Remove the control box from the unit.(Fig. 22 - page 12)
2. Remove the plastic insultation from the switch.
3. Unclip the switch from between the mounting posts.
4. Unplug the wires from the switch terminals.
13