Installing A Dimm - HP ProLiant WS460c G6 Workstation Blade User Manual

•
UDIMM
First: A and B
o
Last: D and E
o
Do not populate slots C or F.
o
After installing the DIMMs, use RBSU to configure the system for Lockstep memory support
lockstep memory" on page 49).
Multi-processor Lockstep population order
For Lockstep memory mode configurations with multiple processors, populate the DIMM slots for each
processor in the following order:
•
RDIMM
First: A and B
o
Next: D and E
o
Do not populate slots C or F.
o
•
UDIMM
First: A and B
o
Last: D and E
o
Do not populate slots C or F.
o
After installing the DIMMs, use RBSU to configure the system for Lockstep memory support
lockstep memory" on page 49).

Installing a DIMM

CAUTION:
air baffle, drive blanks, and access panel must be installed when the server is powered up.
Power down the server
1.
Remove the workstation blade (on page 13).
2.
Remove the access panel (on page 14).
3.
Remove all DIMM baffles
4.
Open the DIMM slot latches.
5.
To avoid damage to the hard drives, memory, and other system components, the
("Power down the workstation
("Remove the DIMM
blade" on page 12).
baffle" on page 14).
Hardware options installation 31
("Configuring
("Configuring