Table of Contents
Advertisement
5.3 Preparing the remote control
Inserting the battery
For first time activation you only need to pull out the
protective foil that protudes from the battery com-
partment in order to prepare the remote control for
operation.
For future battery changes proceed as follows:
1.
Pull the battery compartment out of the remote
control.
2.
Remove the depleted battery and insert a new
battery of the type CR2025 (Button cell) into
the battery compartment. Make sure that the
battery is inserted in accordance with its cor-
rect polarity.
3.
Slide the battery compartment back into the
remote control.
Using the remote control
•
Point the remote control to the Infrared sensor
on the front panel of the device.
•
You can use the remote control for distances
of up to approx. 8 m from the device.
6. Connections and connection
potentials
In order to use the device you need only to provide
a power supply. You can connect it to a power socket
via the rechargeable battery or you can run it with
the 12V vehicle adapter.
In addition the device can be connected to other
input and output devices:
•
with a television set
•
with a video or DVD recorder
•
with a receiver, also, for example, a stereo
system
•
with a Dolby Digital system
Attention!
Make sure that all devices are switched off be-
fore you connect them. Do not plug the device
into the mains power until all connections have
been made.
6.1 Mains power connection
Connection with the power supply unit
1.
Plug the device plug of the supplied power
supply unit into the socket on the side of the
device
2.
Plug the power supply unit into a power
socket.
- 8 -
Advertisement
Table of Contents
