Transporting Vehicle; Towing; Hauling; Service And Maintenance - Cushman Titan XD Owner's Manual

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

TRANSPORTING VEHICLE

Towing

It is recommended that the vehicle be moved by placing the entire vehicle on a trailer, flat bed truck or other suitable
transport.
5
Before pushing inoperative vehicle set the Run-Tow/Maintenance/Storage switch to the TOW/MAINTENANCE/
STORAGE position to prevent damage to the electric motor and controller.
The Run-Tow/Maintenance/Storage switch is located behind the access panel in the center of the dashboard.
Remove two phillips head screws and swing the panel downward to access the switch. Set the switch to the TOW/
MAINTENANCE/STORAGE position before moving an inoperative vehicle, before performing battery maintenance,
repairs or for prolonged storage.
The TOW/MAINTENANCE/STORAGE position allows the vehicle to roll freely without activating the warning beeper
and eliminating potential damage to the controller or motor. In the TOW/MAINTENANCE/STORAGE position all
power to the motor and controller are shut off.

Hauling

To reduce the possibility of severe injury or death while transporting the vehicle:
Secure the vehicle and contents.
Never ride on the vehicle being transported.
Always check that the vehicle and contents are adequately secured before transporting. The rated capacity of the
trailer or truck must exceed the weight of the vehicle (see GENERAL SPECIFICATIONS for vehicle weight) and load
plus 1000 lbs. (454 kg). Set the park brake and secure the vehicle using ratchet tie downs.

SERVICE AND MAINTENANCE

To reduce the possibility of severe injury or death from improper servicing techniques:
DO NOT attempt any type of servicing operations before reading all notes, cautions and warn-
ings in this manual.
Any servicing requiring adjustments to be made to the powertrain while the motor is running
must be made with both drive wheels raised and vehicle properly supported on jack stands.
To reduce the possibility of motor damage, never operate vehicle at full throttle for more than
4 - 5 seconds while vehicle is in a 'no load' condition.
Reduce the possibility of accidental starting by disconnecting battery at negative terminal
before servicing.
5 - 8
This vehicle is NOT designed to be towed.