Operator Controls And Features; Key Switch; Direction Selector; Volt Accessory Outlet - Cushman Titan XD Owner's Manual

INTRODUCTION
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

OPERATOR CONTROLS AND FEATURES

1. Key Switch

6
5
8
Located on the dash panel, this switch enables the basic 7
electrical system of the vehicle to be turned on and off by
turning the key. To prevent inadvertent operation of the
3
vehicle when left unattended, the key should be turned to
the OFF position and removed.
2. Light Switch
Located on the dash panel, this switch will turn on or off the
tail lights and headlights (if equipped).
4

3. Direction Selector

1
3
Located on the dash panel, this switch permits the selec-
2
tion of either F (forward), R (reverse) or N (neutral, the
position between forward and reverse). Vehicle should be left in neutral with the parking brake engaged and the key
removed when unattended. This vehicle is equipped with an operator present switch and will shutdown if the opera-
tor leaves the vehicle seat without turning the key to off; to restart the vehicle after this, the direction selector must be
set to N and then back to the desired direction before pressing the accelerator pedal.
4. 12 Volt Accessory Outlet (if equipped)
Located on the dash panel, this allows 12 volt electrical items to draw power from the vehicle.Total current draw must
be 10 amps or less.

5. State of Charge Meter

The vehicle is equipped with a state of charge meter located in the dash panel. The state of charge meter indicates
the amount of usable power in the batteries, with 'F' indicating a full charge on the battery pack and 'E' indicating the
battery pack needs to be charged.
6. Hour Meter (if equipped)
Located in the dash panel, the hour meter indicates the total hours of operation.

7. Brake Light

The brake light illuminates when the key is turned to ON and the parking brake is set to remind the operator to
release the parking brake before driving the vehicle.

8. Horn

The horn is operated by pushing the horn button located in the dash panel.
9. Turn Signal Switch (if equipped)
Located on the outside of the steering column. Push the
stalk toward the front of the vehicle to operate the passen-
ger side signal and pull backward to operate the driver side
signal.
10. Hazard Lights (if equipped)
To operate the Hazard lights pull the bar away from the
steering column. To deactivate, temporarily flip the turn sig-
9
nal switch in either direction.
10
3 - 2