Assigning The Recorded Sound To The Pad; Loop Playback Of The Phrase Sample - Akai Professional MPC 1000 Quick Manual

MPC1000 Quick manual
08. Play the CD Player.
The MPC1000 will start the recording automatically when the CD Player starts the playback and the bottom of
the screen will change as below:
Tips: If the recording level is too low, the MPC1000 may not start the recording when you play the CD player. In this
case, go back to step 5 and set the level with the [REC GAIN] knob again.
09. Press the [F6] (STOP) key to finish the recording.
If you do not press the [F6] (STOP) key, the MPC1000 will stop the recording at the time set in the Time field.
When the MPC1000 finishes the recording, the Keep or Retry window will be displayed.
10. Check the recorded sample by pressing [F4] (PLAY) key.
If you press the [F4] (PLAY) key, you can play back the recorded sample until you release the key.
If you do not like the recording, you can remove the recording by pressing the [F2] (RETRY) key.

Assigning the recorded sound to the pad

11. Select the Assign to pad field with the cursor and hit the pad to which you wish to assign
the sample.
The pad number of this pad will be displayed in the Assign to pad field.
1 2 . P r e s s t h e [ F 5 ] ( K E E P ) k e y .
This closes the Keep or Retry window and returns to the RECORD page.
Now you can play the recorded sample with the pads. Hit the pad that you have selected in the step 11 to make
sure the recorded sound will be played.
Tips: The samples will be assigned to the pads of the program that is selected in the Pgm field of the MAIN page. To
assign the samples to a new program, you need to create a new program in PROGRAM mode and select it in
the Pgm field of the MAIN page in advance.
For more information about creating a new program, see the "Creating a program" section of the operator's
manual. (on pagr 58)
Tips: You can play back only a specific part of the sample by adjusting the start/end points.
For more information, see the "Setting the loop" section of the operator's manual. (on page 56)
Tips: You can change the assigned sample or set the playback method in the PROGRAM mode. For more
information, see the "chapter 12 : Program" section of the operator's manual. (on page 58)
-6-