Changing The Filter - Kenmore 970-7030 Series Use & Care Manual

Changing the Filter (Continued)
6. Press a drinking glass against the
water dispenser while checking for
any leaks at the filter housing. Any
spurts and sputters that occur as the
system purges air out of the dispenser
system are normal.
7. After filling one glass of water,
continue flushing the system for about
four minutes.
8. Turn On the ice maker.
9. Press and hold the Water Filter button
on the Ice & Water Dispenser control
panel for three seconds. When the
display changes from Red to Green,
the status has been reset.
Air Filter (select models)
The air filter is located under the utility bin.
Replacing your Kenmoreclean!
Air Filter
To ensure optimal filtering of refrigerator
odors, you should change the air filter
every six months (the filter status light on
the Touch Panel prompts you to replace
the filter after six months).
1. Open the air filter door.
2. Remove the old filter and discard it.
3. Unpack the new filter and slide it into
the housing. The open face of the filter
should be installed facing downward.
4. To close the air filter door, push the top
and bottom to lock the door closed.
5. Press and hold the Air Filter Reset
button on the control panel for three
seconds. When the display changes
from "Replace" to "Good," the status
has been reset.
6. The Air Filter Reset will turn itself off
after a few seconds.
TM
Ordering Replacement Filters
Order new filters through the dealer
where you bought your refrigerator. You
may want to consider ordering extra filters
when you first install your refrigerator.
Air Filter Replacement cartridge,
part #9920
27