TABLE OF CONTENTS
1.
GENERAL
Location of Controls ....................................................... 3
Resetting the Unit ........................................................... 4
Detaching the Front Panel ............................................... 4
Setting the Clock ............................................................. 4
Dismounting the Unit ...................................................... 4
Installation ....................................................................... 5
Connection ...................................................................... 6
2.
......................................................... 8
3.
4.
5.
Test Mode ........................................................................ 13
Tuner Section .................................................................. 14
6.
6-4. Schematic Diagram - MAIN Section (1/2) - ................. 23
6-5. Schematic Diagram - MAIN Section (2/2) - ................. 25
7.
8.
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
........... 10
....................... 13
................................................ 33
............................... 36
- 2 -