Gaggia evolution espresso Operating Instructions Manual page 18

18 INSTALLATION / PRIMING THE PUMP
The messages displayed by the machine during operation are shown on pg. 24.
Check that all components
are positioned correctly.
See
rating plate
Plug the other end of the
cord into a suitable electric
socket.
Wait until a steady stream
of water fl ows out from the
nozzle.
Take out the water tank.
Press the ON/OFF switch Place a container beneath the
to turn on the machine. The steam wand.
light switches on.
Press the button and close
the knob to stop loading
the circuit.
Fill the tank with cold drink-
ing water. Do not exceed the
maximum level.
Remove the container. The machine is ready for
use when the light switch-
es on.
Insert the water tank. Insert the plug into the
socket on the back of the
machine.
Open the knob. Press the button to begin
loading the circuit.
Note: You must prime the
pump before starting up the
machine for the fi rst time, if
it has been inoperative for a
lengthy period or if the water
tank has been completely
emptied.
Wait about 5-6 minutes, so
that the system can warm up
uniformly.