Miele KM 6113 Operating And Installation Instructions page 51

Problem
The sensor switches
show increased
sensitivity or fail to
react.
F lights up in the
back left display, E
lights up in the back
right display and the
front displays show
numbers.
left right
9 0
9 1
9 2
9 3
3 7
4 4
4 7
4 8
All other faults
Possible cause
The sensitivity level of the sensor
switches has changed.
There has been an alignment fault
after resetting the appliance or after a
power cut. If the display doesn't
switch off after 5 minutes, proceed as
described on the right.
The overheating protection
mechanism has been activated.
The fan is blocked or faulty.
There has been a fault in the
electronics.
Problem solving guide
Remedy
Make sure that there is no direct light
(from the sun or from an artificial
source) falling onto the cooktop. The
area surrounding the cooktop must
not be too dark.
Make sure the cooktop or the sensor
switches aren't covered. Take any
pans off the cooktop and wipe away
any food deposits.
Interrupt the power supply to the
cooktop for approx. 1 minute.
If this does not solve the problem,
please call Miele.
This doesn't indicate a fault. You can
continue operation as soon as the
fault message has disappeared (see
"Overheating protection").
Check whether the fan is blocked by
an object, e.g. a fork, and remove the
obstruction.
If the fault message does not
disappear, call Miele.
Interrupt the power supply to the
cooktop for approx. 1 minute.
If the problem persists after
reconnecting the appliance to the
power supply, please contact Miele.
51