2. Intended Use 3. Technical data 4. Safety instructions 5. Before starting the appliance 6. Assembling the food processor 6.1 Fitting the mixing bowl...3 6.2 Fitting the lid...3 6.3 Insert the ingredient by filling shaft and pusher ...4 7. Working with the mixing bowl 7.1 Working with the cutting blade...4...
• Prior to initial use clean all device components as described in the “Cleaning” chapter. • Assemble the food processor and note that… - The food processer is in a firm and stable posi- tion. Secure the food processor on the working surface with the four suction cups.
• Remove the cutting blade z from the protective case u. • Fit the mixing bowl 9 to the food processor. • Fit the cutting blade z on the retainer r and place the lat- ter on the drive shaft 8.
Hints: • Cut the ingredients into approx. 3 cm size pieces before adding them to the bowl 9. • The appliance chops the ingredients very fast, therefore allow the appliance to run only briefly. • Do not allow the appliance to run for more than 1 minute at a time.
• Place the mixing bowl 9 on the food processor. Select the appropriate disc. • Place the disc with the lea- ding edge (the side without the ring marking on the cor- ners) in the disc holder i.
• Place the lid 0 on the bowl 9 and the pusher w in the filling shaft q. • Set the speed controller 7 to the level recommended in the table. Hints: • Put liquid ingredients into the bowl 9 last and start mixing at low speed to avoid splashing.
• If the appliance has not cooled off completely after 15 minutes, it will not start. Wait another 15 minutes before switching it on again. If the food processor does not switch on: • Check whether the power plug is inserted in the socket.
14. Table for ingredients The following tables should serve you as examples for orientation as regards which ingredients should be processed in what quantities and at what speed level. Do not exceed the specified operating period to avoid overheating of the appliance. In addition to the 3 levels, a short powerful spurt of operation is available with the pulse stage “P”.