Table of Contents
Advertisement
Function Code 5: Copy Drive Dump
Function Code
to the beginning of a scratch (blank) data cartridge.
1. Place the drive in maintenance mode. For instructions, see "Entering
2. Press the Unload Button once per second to cycle through the following
3. Press and hold the Unload Button for three or more seconds, then release it to
4. Insert a scratch (blank) data cartridge that is not write protected (or the tape
36
IBM TotalStorage Ultrium Tape Drive
5
copies data from a drive dump (captured in Function Code 4)
Attention
5
1
For the
-
function, insert only a scratch (blank) data cartridge or a
cartridge that may be overwritten. During the test, the drive overwrites the
data on the cartridge.
Maintenance Mode" on page 32.
functions:
5
0
: no function
v
-
1
5
: copy dump to tape
v
-
5
8
: copy dump to flash memory
v
-
5
3
: erase flash memory
v
-
If you cycle past the desired code, press the Unload Button once per second
until the code reappears.
select one of the above functions. The SCD changes to a flashing
drive exits maintenance mode). The SCD flashes the selection number while
performing the function.
Note: If you inserted an invalid or write-protected tape cartridge, error code
7
appears in the SCD. The tape drive unloads the cartridge and exits
maintenance mode.
v If the copy operation completes successfully, the tape drive rewinds and
unloads the tape, and exits maintenance mode.
v If the copy operation fails, an error code appears in the SCD. To determine
the error, locate the code in Table 15 on page 75. The tape drive unloads the
tape cartridge and exits maintenance mode.
C
.
Advertisement
Table of Contents
