Table of Contents
Advertisement
Function Code 5: Copy Drive Dump
|
|
|
5
Function Code
copies data from a drive dump (captured in Function Code 4)
to the beginning of a customer-supplied scratch (blank) data cartridge.
Attention
5
1
For the
-
function, insert only a customer-supplied scratch (blank)
data cartridge or a cartridge that may be overwritten. During the test, the
drive overwrites the data on the cartridge.
1. Place the drive in maintenance mode. For instructions, see "Entering
Maintenance Mode" on page 68.
2. Press the Unload Button once per second to cycle through the following
functions:
5
0
: no function
v
-
1
5
: copy dump to tape
v
-
5
8
: copy dump to flash
v
-
5
3
: erase flash
v
-
If you cycle past the desired code, press the Unload Button once per second
until the code reappears.
3. Press and hold the Unload Button for three or more seconds, then release it to
select one of the above functions. The SCD changes to a flashing
4. Insert a customer-supplied scratch (blank) data cartridge that is not write
protected (or the tape drive will exit maintenance mode). The SCD flashes the
selection number while performing the function.
Note: If you inserted an invalid or write-protected tape cartridge, error code
7
appears in the SCD. The tape drive unloads the cartridge and exits
maintenance mode.
v If the copy operation completes successfully, the tape drive rewinds and
unloads the tape, and exits maintenance mode.
v If the copy operation fails, an error code appears in the SCD. To determine
the error, locate the code in Table 13 on page 61. The tape drive unloads the
tape cartridge and exits maintenance mode.
Appendix B. Diagnostic and Maintenance Functions
C
.
73
Advertisement
Table of Contents
