Preparing The Rds Radio Alarm For Operation; Setting The Date And Time; Automatic Setting Of The Date And Time - E-Bench KH 2295 Operating Instructions Manual

6. Preparing the RDS Radio
Alarm for operation
1
Carefully take the RDS Radio Alarm out of
the packaging.
|
Attention!
Do not allow the RDS Radio Alarm to fall! It
could become irreparably damaged.
2
Place the RDS Radio Alarm only on a level,
scratch resistant and non-slip surface.
The feet on the rear of the RDS Radio Alarm
can be adjusted to three levels. You can thus
set the slant of the RDS Radio Alarm to
your wishes. However, ensure that both feet
are adjusted to the same angle. Otherwise
the RDS Radio Alarm will be unstable and
could fall down.
3
Unwind the power cable
Insert the plug into a power socket. The dis-
play will light up. The automatic sta-
d
tion scanner starts, visible in the running of
the frequencies in the display
about 30 seconds.
After this, the RDS Radio Alarm is ready for op-
eration.

7. Setting the date and time

7.1 Automatic setting of the date and
time
The clock of the RDS Radio Alarm is fitted with
automatic time and date adjustment by means
of RDS. It equalises running errors and also the
change over from summer to winter time (and
back again).
|
10
 
to its full length.
2#
. This takes
d
ô
Notice:
RDS means "Radio Data System". It is a system
for transmitting additional information with
radio programmes. Additional information is
for example the name of the station, which is
shown in the display of the RDS receiver. Addi-
tionally, the RDS Radio Alarm uses RDS for the
reception of time signals for the automatic ad-
justment of time and date settings.
After insertion of the plug in the power socket
the radio of the RDS Radio Alarm is switched
on. The automatic station scanner starts for sev-
eral seconds, recognisable in the running of the
frequencies in the display
breaks off the station scan; shown in the display
are the date "01-01-07" and the time "0:00".
d
After a few seconds the time display changes
over "1:00" and "1:59" to "2:00". The station
scanner starts again; the clock in the radio alarm
is now trying to receive date and time informa-
tion over RDS. The clock symbol in the display
blinks until a stable RDS reception is available.
This can take several minutes. When time and
date information is received, the radio switches
itself off for the moment. In the display the cur-
rent date and the current time is then displayed.
ô
Notice:
In general, the date is only shown in the display
when the radio is switched off.
After a few seconds the automatic station scan-
ner starts again. The radio scans the frequency
range for receivable VHF/FM radio stations and
saves them automatically to fixed programme
positions. Thereby, the clock symbol blinks in
the display again.
d
As soon as the frequency ranges are fully
scanned, the radio remains switched on; the
last-saved radio station is playing.
Should no time or date information be received
by means of RDS, there begins ...
. Subsequently it
d