Table of Contents
Advertisement
8. Sewing Light
Face Plate
To replace:
Loosen the setscrew and remove
the face plate to the direction of
arrow.
Setscrew
Turn the bulb counterclockwise to
remove it.
Turn t the bulb clockwise to
replace it.
Bulb
10. Removing and Inserting the Bobbin Case
Open
Open the hook cover.
11. Winding the Bobbin
1
6
1 Pull the handwheel out to the right.
2 Pull the thread from the spool and draw it around the thread guides.
3 Draw the thread through the hole on the bobbin from the inside to outside, put
the bobbin on the bobbin winder spindle and push to the right.
4 Hold the free end of the thread with your hand and depress the foot control.
5 Stop the machine when it has made a few turns. Cut the thread close to the
hole on the bobbin. Depress the foot control again.
When the bobbin is fully wound, push the bobbin winder spindle to the left and
cut the thread.
6 Push the handwheel in for sewing.
Note: Do not move the bobbin winder spindle while the machine is running.
9. Spool Pin
The spool pin holds the spool of thread for feeding the
thread to the machine.
Pull out the spool pin and place the felt on it.
Raise the needle by turning the handwheel
toward you.
Lift the latch and pull out the bbobin case.
2
Finger
Latch
Latch
When inserting the bobbin case,
place the finger into the recess of
the hook race.
Felt
Spool pin
Hook race recess
Bobbin winder
stopper
Bobbin winder
spindle
3
4
5
Hide quick links:
Advertisement
Table of Contents
