Name Of Parts; Free Arm Sewing; Controlling Sewing Speed; Raising And Lowering The Presser Foot - Janome HF106 Instructions For Use Manual

1. Name of Parts

11
1
2
3
4
5

3. Free Arm Sewing

Extension table

5. Controlling Sewing Speed

The foot control regulates sewing speed.
The harder depress the foot control, the faster the
machine runs.

6. Raising and Lowering the Presser Foot

10
9
8
6
7
For free arm sewing, pull out the
extension table to the left and
remove it.
To replace extension table:
Slide the extension table along
the free arm inserting the tab
into the slot.
Accessory kit
Standard accessories are
located inside the extension
table.
Accessory storage
The presser foot lifter
raises and lowers the
presser foot.
You can raise it about 1/4"
higher than normal up
position.
This helps when removing
the foot or when sewing
thick materials.
1. Thread guide
12
2. Thread take-up lever
3. Tension dial unit
4. Extension table
5. Presser foot lifter
6. Reverse button
7. Pattern selector dial
8. Handwheel
9. Bobbin winder stopper
10. Bobbin winder spindle
11. Bobbin winder thread
guide
12. Spool pin
4. Power Connection
Power switch
1. Turn the power switch off. Insert the machine plug into
the machine socket.
2. Insert the power plug into the power outlet. Turn the
power switch on.
Disconnect the power plug when the machine is not in use.
Operating Instructions:
The symbol " " of a switch indicates the "OFF" position of a switch.
For appliances with a polarized plug (one blade is wider than the other).
To reduce the risk of electric shock, this plug is intended to fit in a polarized
outlet only one way. If it does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
Foot controller Model YC-482-J or TJC-150 is used with sewing machine
Model HF106.
7. Changing the Needle
To remove the needle:
Loosen the needle clamp screw by turning
it toward you.
Remove the needle by pulling it downward.
To replace the needle:
Insert a new needle into the needle clamp with
flat side away from you.
Push the needle up as far as it will go.
Tighten the needle clamp screw firmly with a
screwdriver.
2. Standard Accessories
Bobbins
Seam ripper
Felt
Buttonhole foot
Power outlet
Machine socket
Machine plug
Needles
Power plug