Airflow Direction Adjustment - Mitsubishi Heavy Industries DXK09Z5L-S User Manual

Airflow direction adjustment

■ Up/down direction can be adjusted with the AIRFLOW button on the remote control. Every time you press this button the mode
changes as follows:
Change on AIRFLOW (UP/DOWN) mode.
NOTE FOR HEATING OPERATION
• When operation starts, the flap direction is fixed at the horizontal position in order to avoid cold draft, and return to the set the position that was set
after the warm air supply is starting.
• The flap direction will be controlled to the horizontal position when the room temperature reaches the set temperature and compressor stops or when
defrosting is in operation.
• The airflow direction cannot be set during the period mentioned above. Change the airflow direction settings after the warm air is supplied and the
flap goes to the set position.
MEMORY FLAP (FLAP STOPPED)
When you press the AIRFLOW button once while the flap is operating, it stops swinging at the
position. Since this angle is memorized in the microcomputer, the flap will automatically be set
at this angle when the next operation is started.
• Do not expose directly to airflow from the air-conditioner for a long time.
• When in COOL or DRY operation, do not operate for a long period with the
airflow blowing straight down. Otherwise, condensation may appear on
the outlet grill and drip down.
• Do not try to adjust the flaps by hand, as the control angle may change or
the flap may not be closed completely.
■ Adjust the direction by moving the left/right louver by hand.
When you adjust the direction, touch the operation point of louver.
• Please stop the air conditioner when adjusting the air flow direction.
Adjusting airflow direction
(Flap stopped)
WARNING
CAUTION
Adjusting left/right air flow direction
CAUTION
– 12 –
(Swing)
• Recommended angle of the flap when stopping
HEAT
COOL, DRY
Operation point
Louver
Flap
(Slant forward
blowing)
(Horizontal
blowing)