Table Of Adjustment Menus - NEC NC1100L-A User Manual

4. Using Menus

4-2. Table of adjustment menus

Menus in parentheses are menus for our service personnel. Normally, these menus cannot be used.
Main menu
Title Select "Title Memory Name"
TEST Pattern
Configuration Light Setup
Lens Control
Reset
(Setup)
Installation (Note)
(Memory)
(Lens FW Update)
(Title Setup) Preset Button
40
Submenu
Selects the title of the signal to be projected.
Selects the test pattern to be projected.
Adjust Adjusts the light source brightness (output).
Lens Position Adjusts the position of the projected screen.
Focus Zoom Adjusts the size and focus of the projected screen.
(FactoryDefault) Returns the settings to their default values. Selects between preset but-
tons and titles only, LAN settings only and all settings.
Filter Usage Initializes the air filter usage time (for confirming the filter replacement
time).
FilterCleaning Initializes the air filter usage time (for confirming the filter cleaning time).
(Fan Usage) Initializes the usage time of the fan.
(Light Usage) Initializes the usage time of the light source.
(Phosphor) Initializes the usage time of the phosphor.
(Diffuser) Initializes the usage time of the diffuser.
(LCS) Initializes the usage time of LCS (Liquid Cooling System).
(Douser Count) Resets the number of times the douser has been used.
Douser Setup Sets the douser open/close state.
Panel Key Lock Locks the buttons on the projector's control panel so that they cannot be
operated.
Auto Key Lock Enables or disables Auto Key Lock.
3D Connector Sets the signal input terminal for a 3D image system (3D terminal or
GPI/O terminal).
Off Timer Sets the time until the projector power is turned off automatically.
Filter Message Sets the time to display the message indicating the air filter replacement
cycle.
Silent Mode Selects whether to use the status indicator (SYSTEM / LIGHT), buzzer,
indicators on the control panel and backlight.
(Option Slot) Configures the device installed in slot A (only when the projector is in
standby mode).
(Orientation) Sets the projection method and cooling fan operating mode.
Lens Type (Note) Sets the type of lens (supports or does not support the lens memory func-
tion) attached to the projector.
Lens Calibrate (Note) Performs calibration on lens that support the lens memory function (only
when the projector power is turned on).
Lens Center (Note) Moves the lens shift position to the center (only when the projector power
is turned on).
(Baudrate) Sets the PC control connector (RS-232) data transmission speed (bps).
(Date/Time) Sets the date and time on the projector.
(NewRouterSetup) Sets the router with the default settings when the router built-in the
projector has been replaced.
(Fan Speed Mode) Sets the cooling fan operating mode.
(Service Adj.) (Only when the projector is in standby mode)
This is used during shadow adjustment and lens mount adjustment (focus
balance adjustment).
(LD Calibrate) Performs calibration of the light module when the light module has been
replaced (only when the projector power is turned on).
Light The content of the selected light memory (light output power value) can
be overwritten with the current settings.
Lens The content of the selected lens memory can be overwritten with the cur-
rent settings.
This will be used to update the lens firmware in the future.
Preset Button 1–16 Sets the title to be assigned to the preset buttons (<1> to <8> buttons).
Description
Reference
page
42
42
43
43
43
-
43
44
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
44
44
44
-
-
-
-
-
-
-
-
-
45