Connecting A Tv - Sanyo HVR-DX625H Instruction Manual

Connecting a TV

Choose one of the following TV connections,
depending on the capabilities of your equipment.
Rear of TV
COMPONENT/PROGRESSIVE VIDEO INPUT
Y
Pr Pb
C S
Rear of DVD Recorder + VCR
RF Connection
Connect the RF OUT (TO TV) jack on the DVD
Recorder + VCR to the antenna in jack on your TV
using the supplied 75-ohm RF cable (R).
This set doesn't have a modulator output.
However it still applies the RF through
Output.
Audio/Video Connection
1
Connect the VIDEO OUT jack on the DVD
Recorder+VCR to the video in jack on your TV
using the supplied video cable (V).
2
Connect the Left and Right AUDIO OUT jacks
from the DVD Recorder+VCR to the left/right
audio in jacks on your TV using the supplied
audio cables (A).
S-Video Connection
1
Connect the S-VIDEO OUT jack on the DVD
Recorder + VCR to the S-Video in jack on your
TV using an S-Video cable (S).
2
Connect the Left and Right AUDIO OUT jacks
from the DVD Recorder + VCR to the left/right
audio in jacks on your TV using the audio cables.
16
S-VIDEO ANTENNA
VIDEO
INPUT AUDIO INPUT INPUT
INPUT
L R
A V
R
Component Video Connection
• If your television is a high-definition or 'digital
ready' television, you may take advantage of the
DVD Recorder + VCR's Progressive Scan output
for the highest video resolution possible.
• If your TV does not accept the Progressive Scan
format, the picture will appear scrambled.
1
Connect the COMPONENT VIDEO OUT jacks on
the DVD Recorder + VCR to the corresponding in
jacks on your TV using a Y Pb Pr cable (C) if the
component (Y, Pb, Pr) is available on your TV.
2
Connect the Left and Right AUDIO OUT jacks
from the DVD Recorder + VCR to the left/right
audio in jacks on your TV using the audio cables.
• Be sure to set the DVD Recorder + VCR to
Progressive Scan mode by changing the
'Video Output' in the Setup Menu; see page
24.
• Progressive Scan does not work with the RF,
Audio/Video or S-Video connections.
Connections