Table of Contents
Advertisement
5. Installation and operation
5.1 Safety instructions
WARNING! Electrical hazard!
The device must only be connected to a properly installed single socket with
protective contact.
Never yank cord to disconnect from outlet.
Cable must not touch any hot parts.
•
See that the cable does not touch any heat sources or sharp edges. Do not let the
cable dangle over the counter edge.
•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
NEVER deactivate or remove the safety device.
Mechanical safety parts:
Knife cover;
-
Knife protective ring;
-
Pusher handle with a distance element;
-
Pusher cover;
-
Electrical safety parts:
Micro switch
-
↳ ↳ ↳ ↳ stops the slicer if the operator loosens the knife adjustment screw and
makes it impossible to turn the unit on until the cover comes back to a
proper position.
START / STOP buttons
-
↳ ↳ ↳ ↳ in case of lack of electricity supply the unit may be turned on again only
by another use of this button.
•
Do not move or tilt the device when in operation.
- 29 -
Advertisement
Table of Contents
