Kenmore 625.75130 Use & Care Manual page 17

OPTIONAL SETTINGS:
SALT EFFICIENCY
CLEAN FEATURE
CLEAN FEATURE MINUTES
12 / 24 HOUR CLOCK
GALLONS / LITERS
MAXIMUM DAYS BETWEEN REGENERA-
TIONS
1. To set any of these options, press and hold SELECT 1
for 3 seconds until "000" shows in the display. Then
press (do not hold) SELECT 1 again to display one of
the "Salt Efficiency" screens shown below.
Efficiency Icon
SALT EFFICIENCY: When this feature is ON, the
water softener will operate at salt efficiencies of
4000 grains of hardness per pound of salt or higher.
The softener may recharge more often using smaller
salt dosage and less water. This softener is shipped
with the efficiency feature set OFF. Use the
s
DOWN buttons to change between OFF and ON.
Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com
Controller Features Controller Features
2. Press SELECT 1 again to display one of the "Clean"
Figure 26
3. Press SELECT 1 again to display the "Clean Time"
r
UP or
screens shown below.
CLEAN: This feature is beneficial on water supplies
containing iron and/or high amounts of sediments
(sand, silt, dirt, etc.). When set to ON, a backwash
and fast rinse cycle will occur first, preceding the
normal regeneration sequence. This provides extra
cleaning of the resin bed before it is regenerated
with the salt brine. To conserve water, if your water
supply does not contain iron or sediments, be sure
this feature is set to OFF. The default is OFF. Use
r s
the UP or DOWN buttons to change between
OFF and ON.
screen shown below.
CLEAN FEATURE MINUTES: If you have set the
Clean Feature ON, the length of the extra backwash
cycle automatically is set to 7 minutes. However,
you can adjust this time from 1 to 15 minutes in
length. To change this cycle time, use the
ton to increase the time, or the
shorten the time. If no change is desired, continue to
next step.
Figure 27
Figure 28
r
UP but-
s
DOWN button to
continued on next page
17