Setting The Password - Saeco Lirika Operating Instructions Manual

Machine Installation - Service Provider Manual

10.4 Setting the PASSWORD

The PASSWORD must be set by the service provider in order to
prevent access by unauthorised personnel who could change the
machine settings and cause malfunctions.
To set the PASSWORD, proceed as follows:
1 Switch to programming mode as described in section 10.1.
2 Press the " " button (24) until the following menu is dis-
played:
PASSWORD
3 Press the " " button (18) or the " " button (20) to select
"YES".
PASSWORD
4 Press the " " button (24) to confi rm.
PASSWORD
CHANGE PSW
The option "CHANGE PSW" will be displayed, which will allow
5
the password to be set.
6 Press the " " button (21) to confi rm and to set the pass-
word.
SET PSW
0 0 0 0
CONFIRM
• 32 •
To enter the password:
7 Press the " " (18) or " " (20) button to set the desired
number.
Press the " " button (24) to move on to the next number
8
(when it gets to the end it will start again from the beginning).
9 Repeat steps 7 and 8 until the set password has been entered.
10 Press the " " button (21) to confi rm the password and to
exit the menu.
Note: You can exit the change menu at any time
without saving the setting by pressing the "
button (22).
Note: If "NO" is selected from the "PASSWORD"
menu, the saved password will be cancelled.
PASSWORD
"