Kodak EASYSHARE Z812 IS User Manual page 62

Troubleshooting
If
Picture is too light
Picture is not clear
Direct printing (PictBridge) problems
If
Cannot locate desired picture.
The Direct print menu interface
turns off.
Cannot print pictures.
56
Try one or more of the following
■
Reposition camera to reduce the amount of available light.
■
Turn flash off (page
■
Move so that the distance between you and the subject is within the
effective flash range
■
To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■
If using P, A, or S mode, adjust Exposure compensation
■
To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■
Clean the lens (page
■
Make sure camera is not in Close-up/Macro mode if you are more
than 27.6 in. (70 cm) from your subject. (Move further away if you
are using the zoom lens in Close-up/Macro.)
■
Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
Try one or more of the following
■
■
■
■
■
9).
(page 9).
61).
Turn on the camera. Make sure the camera is
accessing internal memory/card or Favorites.
If you are using Direct print, use the menu to change
the image storage location.
Press any button to redisplay the menu.
Ensure that there is a connection between camera
and printer (page 50).
Ensure the printer and camera have power.
www.kodak.com/go/support
(page 41).