Shooting Silent Movie Clips - Kodak EZ 200 User Manual

A low, double tone could also indicate a low light condition. See page 46 in
the Troubleshooting section.

Shooting Silent Movie Clips

You can capture and store up to six, ten-second silent movie clips with your
EZ200 in Digital Camera mode.
The camera sounds a double tone when you start and stop taking the clip.
The picture count on the LCD increases by one.
If the camera beeps a low, double tone and does not operate, make sure the
focus ring is set to the
A low, double tone could also indicate a low light condition. See page 46 in
the Troubleshooting section.
Chapter 3
Press the Mode button until the
1
icon is displayed in the LCD.
2 Set the focus ring to the
position.
3 Center the subject in the viewfinder.
4 Press the Shutter button completely
down to begin taking the silent movie
clip. Release the Shutter button to
end the clip.
Maximum clip length is ten seconds.
position (see page 12).
17