Charging The Batteries - KYMCO MAXER User Manual

BATTERY AND CHARGING THE BATTERY

9.2 CHARGING THE BATTERIES

It is imperative that you observe the sequence for
connecting and disconnecting the battery charger.
1. Position the scooter near an electric outlet.
2. Switch the scooter off and remove the key.
3. Ensure the lever for "freewheel" mode is pushed
down to the "drive" position.
4. Connect the battery charger plug into the scooter
charging socket located in the centre of the tiller.
5. Plug the battery charging power cord (1) into the
socket (2) on the battery charger.
6. Connect the battery charger power plug into an
electrical outlet (AC115-230V, 50 to 60 Hz) and
charge the battery.
7. It is recommended you charge your batteries for 8 to
12 hours.
a grounded supply main.
Step 1. Position the scooter near an electric outlet.
Do not share the outlet with any other
device.
To avoid the risk of electric shock, this
equipment must only be connected to
Never use an extension cord to plug in
your battery charger.
33