Danby Premiere DDR4507EE Owner's Manual page 24

ADR3006==.qxp 2006.02.17
Cleaning
CAUTION: Before attempting to clean and/or service
this unit, always disconnect the power supply cord from
the electrical power supply/outlet.
1. DO NOT use gasoline, benzene, paint thinner, or any
other chemicals to clean this unit, as these substances
will damage/deform both plastic components and luster
finish.
2. Never attempt to clean the unit by pouring water
directly over any of the surface areas, as this will
cause deterioration of electrical components and wiring
insulation.
3. Use only a mild dish washing detergent, lukewarm
water and a soft cloth to wipe the exterior surface of
the unit and dry thoroughly.
TROUBLE SHOOTING GUIDE
Frequently, some problems are of a minor nature and a
service call may not be necessary. Use this
troubleshooting guide to identify possible problems you
may be experiencing. If the unit continues to operate
improperly, call your local Danby
26-DANBY (1-800-263-2629)
for assistance.
PROBLEM
Unit will not operate.
Dehumidifying capacity
(moisture removal) low.
Relative Humidity setting not
reached after long period of
operation.
13:41 Page 26
Care and Maintenance
® Service Depot or 1-800-
Storage
When the dehumidifier is not being used for long time
periods, please follow these instructions.
1. Disconnect the power cord from the power supply.
2. Empty the water tank and wipe (clean) thoroughly.
3. Clean air filter thoroughly
4. Re-package the unit in the original carton.
5. Store the unit upright in a dry location.
POSSIBLE CAUSE
Check power cord connection.
Check electrical outlet for blown fuse.
Check if water tank is full (empty).
Check water tank is properly installed.
Air filter is dirty and/or blocked.
Ambient room temperature too low. (below 5C/41F)
Poor airflow circulation / obstruction of front grill.
Relative Humidity in surrounding environment very low.
Check all doors and windows are closed.
Area/room is too large for the capacity of the dehumidifier.
11