Robot Coupe CMP 250 V.V. User Manual page 7

• Removing the bell from the tube
- Unplug the power mixer.
- Turn the bell in the direction of the arrow
next figure) to separate the bell lug
tube lug .
- Remove the bell.
If jammed, turn the blades inside the bell in the
direction of the arrow to loosen them from the
drive shaft.
• Removing the blades
- Unplug the power mixer then, hold the blades
with the provided blade-locking tool.
- Using the blade-locking tool, unscrew the drive
coupling then remove the blade for easy cleaning.
BLADE LOCKING
BLADES WITH WATERTIGHT SEALS
BELL
DRIVE COUPLING
BLADE REMOVAL
8
- WHISK
• Attaching the whisk holder to the motor unit
(only for CMP Combi)
(see
from the
- Unplug the power mixer.
- Align the flat side
the whisk holder with the catch
of the aluminum casing.
- Insert the conical part
the aluminum casing.
- Turn the whisk holder in the direction of the arrow
(see figure) until it is snugly locked into place.
• Removing the casing
- Unplug the power mixer.
- Turn the whisk holder in the opposite direction
from that used to attach it.
- When it will go no further, remove the whisk
holder from the aluminum casing.
• Fitting the whisk into the whisk holder
of the conical part of
- Grasp the holder in one hand.
on the inside
- With the other hand, take the first whisk and insert
the shaft
of the whisk holder into
drive shaft. Make sure the drive lugs
properly aligned with the notches.
- As you push the whisk into the holder drive shaft
into the notches
locking the whisk into place inside the shaft.
- To check that the whisk is properly fixed inside the
shaft
- Repeat this procedure with the second whisk. If
you cannot push it in properly, remove it, rotate it
90° and start again.
C
D
A
into the bore of the whisk holder
, rotate it slightly in order to slide the drive lugs
of the drive shaft
, gently pull the metal wires.
B
E
are
, thereby