Wire Harness Connections - Brake Switch; Brake Switch Connection; Dome Light Connection - Mazda CX-7 2007 Installation Instructions Manual

10

WIRE HARNESS CONNECTIONS - BRAKE SWITCH

BRAKE SWITCH CONNECTION

1. Locate the 4-pin WHITE brake switch connector at the top of the
brake pedal. (FIGURE MM)
2. Using a razor knife carefully cut back 1"-2" of the electrical tape to
expose the wiring.
NOT TO DAMAGE ANY OF THE WIRES.)
3. Route the red/white remote start harness brake wire between the
dashwall and steering column to the brake switch connector.
4. Using (1) supplied IDC wire tap, connect the wires listed below
and crimp the IDC wire tap in place using pliers. Ensure that a
complete and secure connection is made. Refer to FIGURE MM
& NN for proper connector and pin location.
VEHICLE'S BRAKE WIRE
RED/WHITE
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.
11
WIRE HARNESS CONNECTIONS - DRIVER'S KICK PANEL

DOME LIGHT CONNECTION

1. Locate the 6-pin WHITE connector at the Body Control Mod-
ule mounted in the left kick panel area. (FIGURE OO)
2. Using a razor knife carefully cut back 1"-2" of the electrical
tape to expose the wiring. (
CAREFUL NOT TO DAMAGE ANY OF THE WIRES.)
3. Using (1) supplied IDC wire tap, connect the wires listed be-
low and crimp the IDC wire tap in place using pliers. Ensure
that a complete and secure connection is made. Refer to
FIGURE OO & PP for proper connector and pin location.
VEHICLE'S DOME LIGHT WIRE
BLACK/BLUE
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.
!
( CAUTION: BE EXTREMELY CAREFUL
! CAUTION: BE EXTREMELY
6E 6C 6A
Y/B W/R B
6F 6D 6B
W/B R B/L
VIEW FROM HARNESS SIDE
FIGURE PP
REMOTE START HARNESS WIRE
RED/WHITE
FIGURE OO
REMOTE START HARNESS WIRE
13
FIGURE MM
B B/Y
R/W R
VIEW FROM HARNESS SIDE
FIGURE NN
BLACK/BLUE
4280246 Rev. B 11/10