Replacing The Contact Points - Einstein ET-500 Owner's Manual

REPLACING THE CONTACT POINT
The standard 5/8" contact points are used for most dogs.
Thicker fur breeds require the longer 3/4" contact points.
Replace the 5/8" contact points by following the instructions below
using the enclosed contact point tool.
1. Loosen both contact points by rotating the contact point
counter-clockwise using the contact point tool.
2. Install the 3/4" contact points onto the bolt and tighten the contact
points by rotating them clockwise with the contact point tool.
Replacing the Contact Point
Einstein Owner's Manual ET-500 / ET-502
21