Kodak CX7525 User Manual page 49

Problem Cause
Picture is too The subject was too
light. close for flash.
The light sensor is
covered.
Too much light.
Auto exposure was
not achieved.
Picture is not The lens is dirty.
clear.
Subject too close
when taking picture.
Subject or the camera
moved while the
picture was taken.
Auto-focus was not
achieved.
Camera is in Close-up
mode.
The camera The card may not be
does not SD or MMC certified.
recognize SD or
The card may be
MMC card.
corrupt.
Card is not properly
inserted in camera.
www.kodak.com/go/support
Solution
Move so there is at least 2 ft
(0.6 m) between camera and subject.
Hold the camera so your hands or other
objects do not cover the light sensor
Decrease Exposure Compensation
To take the best possible pictures, press the
Shutter button halfway and hold. When
the ready light glows green, press the Shutter
button the rest of the way down to take
the picture.
Clean the lens (page
Move so there is at least 23.6 in. (60 cm)
between the camera and the subject, or at
least 5 in. (13 cm) at Wide in Close-up mode.
Place the camera on a flat, steady surface or
use a tripod.
To take the best possible pictures, press the
Shutter button halfway and hold. When
the ready light glows green, press the Shutter
button the rest of the way down to take
the picture. (If the orange light blinks, release
the Shutter button and recompose picture.)
Use Close-up mode when subject is 5-28 in.
(13-70 cm) from the lens in Wide Angle; 9-28
in. (22-70 cm) in Telephoto.
Purchase a certified SD or MMC card.
Reformat the card (page
Caution: Formatting deletes all pictures and
videos, including protected files.
Insert a card into the slot, then push to seat
(page 7).
Troubleshooting
(page
(page
52).
22).
i).
18).
43