Problem
Picture is not
clear.
Slide show does
not run on
external video
device.
Chapter 10
Cause
The lens is dirty.
Subject too close when
taking picture.
Subject or the camera
moved while the
picture was taken.
The subject is too far
away for the flash to be
effective.
Auto focus was not
achieved.
Camera is in Close-up
mode.
Video Out setting is
incorrect.
External device is set
incorrectly.
Solution
Clean the lens
(page
Move so there is at least 23.6 in.
(60 cm) between the camera and
the subject, or at least 5.1 in. (13
cm) at Wide in Close-up mode.
Place the camera on a flat, steady
surface or use a tripod.
Move so there is no more than
11.8 ft (3.6 m) between the
camera and the subject; 6.9 ft
(2.1 m) in Telephoto.
To take the best possible pictures,
press the Shutter button
half-way and hold. When the
ready light glows green, press the
Shutter button the rest of the
way down to take the picture. (If
the yellow light blinks, release the
Shutter button and recompose
picture.)
Use Close-up mode when subject
is 5.1-27.6 in. (13-70 cm) from
the lens in Wide Angle; 8.7-27.6 in.
(22-70 cm) in Telephoto.
Adjust the camera Video Out
setting (NTSC or PAL,
page
55).
See the external device's user's
guide.
94).
77