Entone remote Quick Start Manual

QUICK START
remote Guide //
5
3
4
3
2
6
4
3
2
4
Manual Program Remote for Television
1. Visit www.nep.net/remote
TV type and make in the TV Codes pamphlet or pdf.
2. Turn on TV.
3. Hold down the TV button until it lights up and stays lit.
4. Type in a 4 digit code from the TV Codes pamphlet or pdf.
a. Test Volume - press volume up and down
b. Test Power - press Blue Power button at the top of remote
If either test fails go to next code in TV Codes pamphlet/pdf.
If HD codes do not work locate and test SD codes.
5. Once a working code is found hit the STB button to be sure you
can control the Set Top Box.
6. Write working code here for future access:
Auto Program Remote for Television
1. Turn on TV.
2. Hold down the TV button until it lights up and stays lit.
3. Press the Blue Power button once aiming the remote at TV.
4. Press either the Channel Up or Channel Down to start Auto Scan.
5. Auto Scan will test a Code in 5 second intervals. The TV button
will blink everytime a new code is tested.
15 minutes to complete.
6. If / When the TV turns off press the OK button on the remote to
lock in the code.
If all codes have been tested and the OK button was not pressed
the TV key will blink 7 times and Auto Scan will be terminated.
Program NEW Remote to Control STB
1. Program Remote for TV first. See options above.
2. Hold down the STB button until it lights up and stays lit.
3. Press the Blue Power button once aiming the remote at the
Set Top Box.
4. Press the Number 1 button. Remote will be programed to work
that Set Top Box.
nep datastream
to download TV codes or locate your
This can take up to
www.nep.net