Power Connector Cable - HP Compaq Compaq Presario V3000 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
Wireless module compartment cover (see
b.
Optical drive (see
c.
Keyboard (see
d.
Switch cover (see
e.
Display assembly (see
f.
Top cover (see
g.
Speaker assembly (see
h.
Remove the power connector cable:
Disconnect the power connector cable (1) from the system board.
1.
Remove the power connector (2) from the clip built into the base enclosure.
2.
Reverse this procedure to install the power connector cable.
72 Chapter 4 Removal and replacement procedures
Battery on page 36).
Hard drive on page 37)
Optical drive on page
Keyboard on page 46)
Switch cover on page
Display assembly on page
Top cover on page 57)
Speaker assembly on page
WLAN module on page
44)
49)
51)
70)
Spare part number
448629-001
39)
ENWW