Philips 190CW8FB/00 Service Manual page 20

20
HUDSON 8
7. Click Next , bring up Fig. 21.
8. Click Next , bring up Fig. 22, then click "finish".
Step 5: Write DDC data
1. Configuration should be as Fig. 23. And press OK.
2. Click (Write EDID) icon from the tool bar to write DDC data.
Then wait for 20-30 seconds ,DDC data will be finished Writing.
3. Turn off the monitor, press "INPUT" button and hold it , then press
power button to turn on the monitor.(If the power indicator light flicker
twice, it means the S/N has been refreshed into the EEPROM.)
4 Press "MENU" button . The S/N is refreshed in the OSD menu as
Fig.24.
DDC Instructions
Step 6: Save DDC data
Sometimes, you may need to save DDC data as a text file for
using in other IC chip. To save DDC data, follow the steps below:
Fig. 21 1. Click (Save) icon (or click "file"-> "save as") from the tool bar
and give a file name as shown in Fig. 25.
The file type is EDID46 file (*.ddc) which can be open in WordPad.
By using WordPad, the texts of DDC data & table (128 bytes, hex
code) can be modified. If DDC TEXTS & HEX Table ar completely
correct, it can be saved as .ddc flie to re-load it into DDC IC for DDC
Data application.
2. Click Save.
Fig. 22
Step 7: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 26.
Fig. 23
Fig. 24
Fig. 25
Fig. 26