Removing A Water Inlet Valve - Whirlpool LHW0050PQ Service Manual

REMOVING A WATER INLET VALVE

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover from the washer
(see page 4-2 for the procedure).
Water Inlet Valves
4. Disconnect the wire connectors from the
water inlet valve you are servicing.
Red Wires
Hot Water Inlet Valve
5. Remove the two T-20 Torx screws from
the water inlet valve and remove the valve
from the rear of the unit.
Water Inlet Valve T-20 Torx Screws
4-8
Cold Water Inlet Valve
Black
2 Red