Panasonic PP103985 Operating Instructions Manual page 3

Caution
Observe the following cautions when
handling this unit.
q Keep the sound volume at an appropriate level.
Keep the volume level low enough to be aware of road
and traffic conditions while driving.
q This unit is designed for use exclusively in
trucks.
q Do not operate the unit for a prolonged period
with the engine turned off.
Operating the audio system for a long period of time
with the engine turned off will drain the battery.
q To ensure safety, never attempt to preset
stations while you are driving.
q Depending upon the transmission condition of
electro-magnetic waves, the geographical
reasons and/or the weather conditions, you may
not receive the NOAA radio partially or at all.
q Make sure that your weather radio can receive
properly before driving, especially, before use
in a critical condition.
q Set the volume level to low enough before the
AUX connection is completed.
Failure to observe this, the loud noise may come out and
damage your speakers and your hearing. Direct connec-
tion of the speaker/headphone output of an external device
without any attenuator may distort sound or damage the
connected external device.
Observe the following cautions when
installation.
q Refer wiring and installation to qualified
service personnel.
Installation of this unit requires special skills and
experience. For maximum safety, have it installed by the
dealership. We are not liable for any problems resulting
from your own installation of the unit.
q Follow the instruction to install and wire the
product.
Not following the instructions to properly install and wire
the product could cause an accident or fire.
q Take care not to damage the leads.
The following applies only in the U.S.A.
Part 15 of the FCC Rules
FCC Warning:
This device complies with Part 15 of the FCC Rules
for Radio Receiver. Operation is subject to the condi-
tion that this device may not cause harmful interfer-
ence. Any unauthorized changes or modifications to
this equipment may void the user's authority to oper-
ate this device.
When wiring, take care not to damage the leads. Prevent
them from getting caught in the vehicle chassis, screws,
and moving parts such as seat rails. Do not scratch, pull,
bend or twist the leads. Do not run them near heat
sources or place heavy objects on them. If leads must be
run over sharp metal edges, protect the leads by winding
them with vinyl tape or similar protection.
q Use the designated parts and tools for
installation.
Use the supplied or designated parts and appropriate
tools to install the product. The use of parts other than
those supplied or designated may result in internal
damage to the unit. Faulty installation may lead to an
accident, a malfunction or fire.
q Do not block the air vent or the cooling plate of
the unit.
Blocking these parts will cause the interior of the unit to
overheat and will result in fire or other damage.
q Do not install the product where it is exposed to
strong vibrations or is unstable.
Avoid slanted o strongly curved surfaces for installation.
If the installation is not stable, the unit may fall down
while driving and this can lead to an accident or injury.
q Installation Angle
The product should be installed in a horizontal position
with the front end up at a convenient angle, but not more
than 30˚.
The user should bear in mind that in some areas there
may be restrictions on how and where this unit must be
installed. Consult your dealership for further details.
q Wear gloves for safety. Make sure that wiring is
completed before installation.
q To prevent damage to the unit, do not connect
the power connector until the whole wiring is
completed.
q Do not connect more than one speaker to one
set of speaker leads. (except for connecting to a
tweeter)
3