Daily; Every Week - HTC 950 RX Manual

Maintenance and repairs
• Recharge/replace the batteries when L" appears in the display and blinks quick,
see Figure 3-4, page
Procedure:
1. Stop the machine, see
2. Loosen the battery cover by screwing the screws out on the cover
3. Remove the old/flat batteries.
4. Replace with the new/charged batteries.
5. Close the cover and fasten it in place with the screws.
6. Start the machine, see
5.5

Daily

• Wash the machine, if it is used for wet grinding or with the Mist Cooler system.
• Check for wear to the grinding tool – abnormal or uneven wear may indicate a
damaged grinding holder.
• Check the tool holder and grinding holder to ensure that no damage or cracks
have arisen. Replace the parts if there is any damage.
• Remove any residues of building material from the radio control unit.
5.6

Every week

• Wash the machine.
• Check the grinding holders. Remove the tools and run the machine in mid air at
the slowest speed. If the grinding holders oscillate or wobble significantly, they
are damaged.
• Check that the upper belt is whole, by turning the large disc in one direction or
the other. If there is resistance the belt is whole, if the disc rotates freely the belt
is broken.
Tip!
Recondition all the grinding holders at the same time.
34
13.
under Stop the machine - Radio control, page
under Start the Machine - Radio Control, page
HTC 950 RX
30.
29.
1.0