Daily; Every Week - HTC 800 RX Manual

HTC 800 RX
• Recharge/replace the batteries when L" appears in the display and blinks quick,
see Figure 3-4, page 13.
Procedure:
1. Stop the machine, see under Stop the machine - Radio control, page 30.
2. Loosen the battery cover by screwing the screws out on the cover
3. Remove the old/flat batteries.
4. Replace with the new/charged batteries.
5. Close the cover and fasten it in place with the screws.
6. Start the machine, see under Start the Machine - Radio Control, page 29.
5.5

Daily

• Wash the machine, if it is used for wet grinding or with the Mist Cooler system.
• Check for wear to the grinding tools – abnormal or uneven wear may indicate a
damaged grinding holder.
• Check the tool holder and grinding holder to ensure that no damage or cracks
have arisen. Replace the parts if there is any damage.
• Remove any residues of building material from the radio control unit.
5.6

Every week

• Wash the machine.
• Check the grinding holders. Remove the tools and run the machine in mid air at
the slowest speed. If the grinding holders oscillate or wobble significantly, they
are damaged.
• Check that the upper belt is whole, by turning the large disc in one direction or
the other. If there is resistance the belt is whole, if the disc rotates freely the belt
is broken.
Tip!
Recondition all the grinding holders at the same time.
2.0
Maintenance and repairs
33