Watching Tv; Turning On/Off The Power; Initial Setup - Sharp Aquos LC-46SE94U Operation Manual

Watching TV
Turning On/Off the Power
trr~~~===~~
TV POWER
I
T v j TV VCR Aumo
' I
(On/Standby)
I
IJ
CB~SAT o~o FU~ON
I
\
SOURCE LIGHT
I
88CIDI
I~
II
I
I.I~
i l l
.----:r
!---.
~WER
I
'In
POWER
MENU
o
INPUT
o
Press POWER on the
N,
or TV POWER on the remote control unit to
turn the power on.
• POWER indicator (Blue): The lV is on. (After a few seconds, a window
appears with sound.)
mm
• The initial setup starts when the lV powers on for the first time. If the lV has
been turned on before, the EZ Setup will not be invoked. See page 24 for
performing EZ Setup from the Setup menu.
Press POWER on the N, or TV POWER on the remote control unit
again to turn the power off.
• The lV enters standby and the image on the screen disappears.
• The POWER indicator on the lV turns off.
mm
• If you are not going to use this lV for a long period of time, be sure to remove
the AC cord from the AC outlet.
• Weak electric power is still consumed even when the lV is turned off.
Initial Setup
When you turn on the N for the first time, it will
automatically memorize the broadcasting channels
available in the region where you live. Perform the
following steps before you press TV POWER on the
remote control unit.
1. Insert the batteries into the remote control unit. (See page 8.)
2. Connect the antenna cable to the lV. (See page 12.)
3. Plug in the AC cord to the AC outlet. (See page 7.)
1
\
' O ZE
~
MOU
II
\
J~~o·1
Language (Language setting)
Select from among 3 languages: English, French and Spanish.
1
Press JIt./T to select the desired language listed on the
screen, and then press ENTER.
TV Location
Select "Home" or "Store" for the location where you plan to
install the lV.
2
Press ....
/~
to select "Home" or "Store".
Press ENTER to enter the setting.
Example
mm
• If you select "Home", AV MODE is set to "STANDARD".
• If you select "Store", AV MODE is set to "DYNAMIC (Fixed)".
In case no remote control signal is received within 30 minutes,
AV MODE will change to "DYNAMIC (Fixed)" automatically.
• For changing the lV Location after the setting, see "EZ
Setup" on page 24.
Air/Cable (Antenna setting)
Make sure what kind of connection is made with your lV
when selecting "Air" or "Cable".
3
Press ....
/~
to select "Air" or "Cable".
Press ENTER to enter the setting.
Example
CH Search (Channel search)
Channel auto search makes the lV look for all channels
viewable in the set area.
4
When "Air" is selected in Antenna setting:
Press ....
/~ to select "Start", and then press ENTER.
When "Cable" is selected in Antenna setting:
Press
J/i..lT
to select "Analog & Digital Search Start" to
search both analog and digital broadcasts, or to select
"Analog Search Start" to search only analog broadcasts,
and then press ENTER.
• The Channel search will start automatically.
• To exit the Channel search screen, select "Cancel", and
then press ENTER.
mm
• If no channel is found, confirm the type of connection made
with your lV and try EZ Setup again.
(See page 24.)
@-15