Loading The Tool - Bostitch CF15 Operation And Maintenance Manual

LOADING THE CF15
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while
the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
Instructions for loading fasteners:
1. Adjust the magazine: Hold the tool with
the nose pointed toward the workpiece.
Depress the appropriate size adjustment
buttons for the desired fastener height.
2. Open the magazine: Pull the pusher
back to engage the latch.
3. Loading fasteners: Insert fasteners as
shown with the proper orientation.
Note: Orientation of fasteners, with sharp
ends pointed down.
4. Close the magazine: Release the
pusher by depressing the pusher release
button and slowly sliding the pusher
against the fasteners towards the nose of
the tool.
1
3a
4a
-6-
2
3b
4b